[FFmpeg-user] FFmpeg_Book.pdf 2.148

[Cecil Westerhof]

Michael Koch <astroelectronic at t-online.de> writes:

> Am 12.06.2023 um 00:00 schrieb Cecil Westerhof via ffmpeg-user:
>> Michael Koch <astroelectronic at t-online.de> writes:
>>
>>> Am 11.06.2023 um 22:39 schrieb Cecil Westerhof via ffmpeg-user:
>>>> In FFmpeg_Book.pdf chapter 2.148 is about video stabilisation.
>>>> Part of the code is:
>>>>       ffmpeg -i %IN% -vf vidstabdetect -y dummy.mov
>>>>       del dummy.mov
>>>>       ffmpeg -i %IN% -vf vidstabtransform -y %OUT%
>>>>
>>>> But line two removes what is generated in line one. So what are thos
>>>> two lines doing?
>>>>
>>> It's described in the documentation for those two filters. The
>>> vidstabdetect filter has two outputs. The stabilization data is written
>>> to a file "transforms.trf", and the output of the filter chain is the
>>> same as the input. Because this output isn't required, it can be
>>> deleted.
>>> The vidstabtransform filter in the third line does by default read the
>>> file "transforms.trf".
>> Ah, I understand. Thanks.
>>
>>
>> Would it not be a good idea to also add a deshake example? Something
>> like:
>>      ffmpeg -i 00105.MTS -vf deshake=rx=64:ry=64:edge=3 -y deshake.mp4
>
> There is a short example for deshake on the next page. But when I
> tested

Yes, but I had to 'translate' that to the above.

-- 
Cecil Westerhof
Senior Software Engineer
LinkedIn: http://www.linkedin.com/in/cecilwesterhof