[MPlayer-dev-eng] [PATCH] autoq support for control()

[Bohdan Horst]

On Sat, Feb 09, 2002 at 09:11:15PM +0200, Arpi wrote:

> Hi,
> 
> > On Sat, Feb 09, 2002 at 06:41:21PM +0200, Arpi wrote:
> > 
> > > anyway, value of autoq depends on a-v desync and idle cpu time. and for
> > > hardware decoders (or -benchmark...), they are unpredictable...
> > > 
> > > autoq will increase postprocess filter level if there is idle cpu (up to
> > > the value specified with -autoq <n>) and will decrease down to 1 if no
> > > idle cpu left. it will disable all postproc (q=0) when a-v gets desyncing.
> > > 
> > 
> > with -nosound  autoq sets quality (output_quality) to fixed value
> > (or output_quality is incorrectly displayed in status line)
> 
> i think it always sets value to 1
> (it sees that cpu usage is 100% so it decreases to the minimum, 1)

then output_quality is incorrectly displayed in status line ..

with -nosound it always display -autoq value ..

-autoq n > output_quality=n
...

best regards

-- 
 / irl:Bohdan 'Nexus' Horst | mailto:nexus at irc.pl | irc:Nexus \
{---------------------------^----------v----------^------------}
 \ http://www.physd.amu.edu.pl/~nexus/ | Instytut Fizyki  UAM /