[MPlayer-users] Ati Tvout with mplayer

nebehajv at freemail.hu nebehajv at freemail.hu
Mon Jun 10 18:55:02 CEST 2002


On Sat, Jun 08, 2002 at 04:41:28AM +0200, Felix Buenemann wrote:
> > I have an Ati XPert 2000 video card (with rage128 chip).
> > The problem is, that the TV out function does not work
> > correctly. If the TV cable is connected during boot,
> > everything works - until I start X. Then the screen blanks.
> > When I switch back to console, again, everything is fine, but
> > the display of X can not be seen at all. I use XFree 4.0.2, and tried
> > with 4.2.0 too, with the gatos driver in both cases.
> > If I change the driver from 'r128' to 'vesa', it works correctly,
> > but the position of the screen can not be adjusted, and with no
> > hardware acceleration (very slow). The vesa driver does not accept
> > modelines I give it, so I can not set the right position.
> > What should I do for correct display? There is no way for the vesa
> > driver to give modelines? Could the original X or the gatos drivers
> > be used with this card and TVout? I need X anyway, because I work on an X
> > application, which uses MPlayer for playing movies.
> 
> RTFM, it's described there (hint: -vo vesa:vidix or sth. like that).

Hi,

Thanx Felix, I _did_ RTFM many times ;) But the main problem still exists:
I can't adjust the position (as I'd do it under X with modelines),
so the output on the TV is shifted to the left. Unfortunately,
I can't set it on the TV, because it works on a closed chain TV network, so
~200 TVs should be set.
So, have you any idea how I can adjust the position using this video output
(or use another vo which works with TVout)?

Thanks,
-- 
[Vilmos Nebehaj]	<nebehajv at freemail.hu>





More information about the MPlayer-users mailing list